Dummyloads, Attenuators

For measurement technology, so-called "dummy loads", i.e. terminating resistors, are essential for transmitter calibration. They make it possible to operate the transmitter with power and to feed the radiated signal with perfect matching to an artificial antenna. The signal is not radiated but converted into heat - hence the often rather big heat sink and the limited operating time. This makes it possible to tune the transmitter without interference.

Attenuators are used to adapt the power - usually in the case of the transmitter - to a low power meter or assembly.

 

Items 1-10 of 18

Filter
  1. MFJ-264 DummyLoad, load resistor 1500 Watt
    MFJ-264 DummyLoad, load resistor 1500 Watt

    Dummyload, max. 1500 Watt, max. 650 MHz, N or PL socket

    In stock, shipped in 1 to 2 days

    As low as: €159.00
    incl. VAT, plus shipping €133.61
  2. 50 Ohm Calibration Kit, SMA
    50 Ohm Calibration Kit, SMA

    50 Ohm Calibration Kit SMA (50 Ohm termination, open, short).

    In stock, shipped in 1 to 2 days

    €24.85
    incl. VAT, plus shipping €20.88
    SKU 21010.SMA
  3. MFJ-260 Dummy Load 25/300W
    MFJ-260 Dummy Load 25/300W

    Dummyload 25 W / 300 W, up to 650 MHz, PL socket.

    In stock, shipped in 1 to 2 days

    €91.90
    incl. VAT, plus shipping €77.23
    SKU MFJ-260
  4. Microset Dummyload CF-300 (Terminating resistor)
    Microset Dummyload CF-300 (Terminating resistor)

    Microset Dummyload CF-300 (terminating resistor) 50 Ohm, 300 W

    In stock, shipped in 1 to 2 days

    €163.90
    incl. VAT, plus shipping €137.73
    SKU 21110

Items 1-10 of 18

Filter