Aceco Frequency counter
The Aceco frequency counter come complete with rechargeable batteries, wall charger (230V) and antenna (BNC jack) in a solid metal case. The counters are very sensitive, when using the supplied telescopic antenna a range of about 20m can be achieved (tested with a FC-2002 sensing a normal 2W handheld with rubber duck antenna). Operating time approx. 6 hrs with fully charged batteries.
More information, datasheets, downloads etc. on the Aceco homepage www.aceco.de.
Concerning the frequency precisison the manufacturer writes:
The timebase of our counters is less than 1 PPM at room temperature. Before shipping all the counters are fully calibrated with an external frequency standard input (HP 8648C Signal Generator).
The stability specifications are as follows:
a. Initial Accuracy at Room Temperature: ±1PPM.
b. Frequency Stability vs. Temperature (-10 to 60°C): ±5PPM in the entire range from -10 to +60°C.
c. Frequency Stability vs. Aging/Year: ±2PPM.
FC-1003
FC-1003
- Frequency range 10MHz - 3GHz
- 8-digit LC display
- Hold button
- Removeable antenna (BNC jack)
- Rechargeable batteries built in
- Wall charger (230V) supplied
- Bargraph for relative strength display
- Range selector 300 MHz/3 GHz
- Variable Gate timing
- Switchable noise filter
| Order No. |
|
|
|
|
|
| FC-1003 |
|
101.97 (99.00) EUR |
Buy now |
FC-2002
- Frequency range 10Hz-3GHz
- Switchable input hi-impedance (10Hz-50MHz, 1MΩ) or 50Ω (1MHz - 3GHz)
- 10-digit backlit LC Display
- Bargraph for relative strength display
- Variable Gate timing
- Measurement of period timing
- Switchable noise filter
- Removeable antenna (BNC jack)
- Rechargeable batteries built in
- Wall charger (230V) supplied
| Order No. |
|
|
|
|
|
| FC-2002 |
|
149.35 (145.00) EUR |
Buy now |
FC-3002
Imagine the following situation: A bus cdrives by you, the driver is on the radio - but on which frequency? No problem with the FC-3002 and an additional scanner the frequency is immediately identified and sent to the scanner.
Like FC-2002, but with the following differences:
- Frequency range 1MHz-3GHz
- Serial interface (output) for control of various scanners (Icom R10, R7000, R7100, R8500, R9000, AOR AR-2700, AR-8000,AR-8200)
- 50 Ω antenna jack
- Cable for Icom scanners is provided (not for AOR)
| Order No. |
|
|
|
|
|
| FC-3002 |
|
156.56 (152.00) EUR |
Buy now |
FC-5002
The FC-5002 is a near field receiver which intercepts automatically and very fast any FM signal between 30 and 900MHz in the vicinity. Works like a scanner, but much faster (less then one second typically).
Ideal for personal security, interception of voice traffic at sport events, testing other radios etc.
- Frequency range 30MHz - 900MHz
- Removeable antenne (BNC jack)
- Rechargeable batteries built in
- Wall charger (230V) supplied
- Adjustable squelch
- Sensitivity approx. 500 mV (-53dBm)
- Ear plug supplied
- CI-V Input(!) for control by Icom scanners or FC-3002
- Hold button
- Relative signal strength display
| Order No. |
|
|
|
|
|
| FC-5002 |
available again in October 2010 |
149.35 (145.00) EUR |
Temporarily not available |
Here you can read a short
review of the FC-5002 (German).
SC-1 Frequenzzähler für digitale und analoge Signale
In contrast to the devices show nabove the SC-1 also detects digital, pulsed signals like DECT- or GSM-phones, WiFI (Wireless LAN) or other digital signals. NB: This device just shows the frequency of the detected signals, actual decoding is not possible.
- Frequency range selectable: 30MHz to 1GHz or 500MHz to 2.8GHz
- 7-digit LC Display
- Bargraph for relative signal strength
- Minimale pulse width 250 micro seconds for digital signals
- Hold button
- Adjustable sensitivity level (squelch)
- Removeable antenna (BNC jack)
- Rechargeable batteries built in
- Wall charger (230V) supplied
| Order No. |
|
|
|
|
|
| SC-1 |
|
163.77 (159.00) EUR |
Buy now |
