Antenna accessories for mobile antennas

On this page you will find:

• Base mounts for fixed installation
• Magnet mounts
• Window Pass Through cable
• Coaxial window pass through with PL connectors
• window clamps
• Cables
• DIAMOND trunk mounts for mobile antennas
• Universal mounting bracket AMK-1

Base mounts for fixed installation

N type or PL type base mount for slanted installation

Tiltable base for all mobile antennas with N or PL connector (WiMo, Diamond, Comet, Maldol...). The amount of tilt can be adjust up to 30 degrees from vertical. These mount are designed to be used on the fender or on the roof of the car. The cable has a length of 4m, different versions with cable mounted sideways or centrally are available. All metallic parts are chrome plated and weatherproof. Outer diameter is 30mm, drill hole diameter is 12 (PL) or 16mm (N).

Very low profile PL base mount

20017

Base mount for all antennas with PL connector. Very low profile, requires very little space inside the car roof (20mm). Complete with 3.5m cable with PL plug.

Base mount for Mercedes-Benz W-124

Base mount for Mercedes-Benz W124 (not for T model), can be mounted in the existing hole in the fender. The original rubber grommets are required for installation.

Heavy PL base mount for larger antennas

The large surface of the mount makes it suitable for larger antennas like the ATAS-120 etc. Outer diameter 40mm, drill hole diameter 16mm, depth 20mm inside. Complete with 4m cable H-155, attached sideways.

Heavy 3/8" base mount for larger antennas

Heavy base mount with 3/8" thread (female). 50mm outer diameter, drill hole diameter 16mm, internal connector PL.

DV base mounts and accessories

DV base for roof mount, only 10mm depth inside the car. With 4m RG-58 cable attached, can also be mounted from the outside. Drill hole diameter 19mm.

DV base mounts in various models, with special connector Order No. 30001 or cable Order No. 20008. Not suitable for use on 70cm band.

Cable with 90 deg. angle connector for DV mount, length 4m.

Magnet mounts

Diamond Magnet mounts

Heavy Diamond magnet base with N or PL jack for any radiator with N or PL plug. Cable 4m long with N or PL connector. DIameter c. 11cm, high quality, also suitable for up to 23cm band.

Diamond Magnet base K-701M

Huge magnet base with c. 16cm diameter, very low profile. With PL jack, PL plug on cable. Very strong hold on flat car roof with the supplied rubber gasket. Cable 4m total length, first part (1m) is thin, low loss RG-188, remaining special low loss cable 7mm diameter.

Diamond Magnet base K-707M

Similiar to K-701M, but only 100mm diameter and with 4m thin cable. PL/PL.

Diamond Magnet base MRX

Small Diamond magnet base with BNC jack for a radiator with BNC plug, with 3m cable with BNC plug. Excellent quality, also suitable for 23cm with the appropiate tri-band antennas.

Mag H12

Magnet base H12, low profile, fixed cable RG-58 attached, for all HF/VHF antennas with PL or DV connector. These magnet bases are not suitable for use on UHF (70cm, 430MHz).

Window Pass Through cable

SMA

Window pass through cable.
Version 40360.N 80cm long, with N plug/N jack.
Version 40360.SMA 30cm long, with SMA plug/SMA jack.

N

Coaxial window pass through with PL connectors

Diamond MGC-50

This pass through cable is made with a solid, flat cable with only 1.7mm thickness and about 44cm free length. The ends are terminated in small boxes which holds a PL connector female each. This cable is useable up to 23cm, the max. power load is 150W on shortwave, max. 40W FM on 2m and max. 30W on 70cm.
To protect the cable against menchanical stress, installation material is included to attach the boxes on the window frame.

MGC-50

MGC-50 Installation

MGC-50 Installation

MGC-50 Installation

MGC-50 Installation

Put the rubber ducky someplace else...

DIAMOND MCR2 Universal BNC holder with knuckle, e.g. place it on the outside rear mirror. Includes 2.5m cable with BNC connector. Order No. 20046 41.80 € Buy now

Solid window clamp

Solid window clamp for any antenna with PL connector. The base can be tilted in any direction so the antenna can be adjusted vertically. LOcks on the glass, so the window can be opened without risk of losing the antenna. Internal connector BNC, includes a 3.5m cable with BNC and PL.

Window clamp

20019 (BNC)

20019 (SMA)

Window clamp for temporary use of a radio in a car, just place the rubber ducky of your handheld radio or any other antenna on the clamp. Includes 2m cable with BNC or SMA connectors.

Cables

Diamond cable harness for trunk mounts with 4 or 6m cable. The first 30cm (100cm with M-610R) are made of very thin cable to fit through the lid, the rest of the cable is made of low loss 6mm cable. Order No. 20052 S-510NN N jack (female) / N plug (male) 5m 46.20 € Buy now 20053 S-405MM PL jack (female) / PL plug (male) 4m 39.00 € Buy now 20054 S-510MN N plug (male) / PL jack (female), 5m 48.90 € Buy now 20055 M-610R Pl plug (male) / PL jack (female), 6m 39.90 € Buy now

Diamond cable harness for trunk mounts with 4m cable, either PL or N connectors. Order No. 20050 ECH, PL connector 14.95 € Buy now

DIAMOND trunk mounts for mobile antennas

New series for all puposes, all in a black anodized finish. Most mounts are tiltable in two directions. If can't drill a hole in the chassis, you will find a solution here. The suitable cable harnesses are shown above (Order No. 20051 - 20053.

Diamond K-401

K-401

Diamond K-402

Solid trunk mount for larger antennas, adjustable.

Diamond K-400

K-400 mounted on the side of a trunk lid, with HF antenna.

Solid trunk mount, black, for larger antennas. Adjustable in two directions.

Diamond K-540

K-540

Diamond K-300

Solid roof railing mount, adjustable by hand, black like all Diamond mounts.

Diamond K-600M

K-600M

Diamond K-550

Solid roof railing antenna, for irregular shaped railings (not round). The flexible belt adjusts to any shape of the railing. Can be tilted in two directions.

Diamond K-501

Diamond K-515

K-515

K-515 Spans max. 48mm horizontal, max. 50mm vertical

Diamond HRK

Diamond HRK

Diamond HRK

Tiltable mount for windows, car roof or any other flat surfaces. The mount is just glued to the surface. Suitable for light antennas up to 1m length and a weight of 200g, for example AZ-504, AZ-510, SG-M805 etc. Requires an additional cable kit, see above.

Universal mounting bracket AMK-1

Mounting bracket AMK-1

Stainless steel, for mounting our cable sets 20050 etc. to a car or motor bike sign plate (check your local vehicle regulations!) or at any other place.

Option: Mast clamp for mounting on a vertical pole or mast, consisting of U bolt, bracket, lock washers and nuts. All stainless steel!

Balcony railing mount for 3/8" antennas

Montagewinkel 11104

Aluminium bracket for installation on a mast, lamp post, railing... 45cm length between mast center and antenna. Includes two U bolts for max. mast diameter 45mm. Install any antenna with 3/8" thread (MP-1, Chaneleon, Outbacker etc.), an isolated mount with 3/8" socket and PL female socket is included (Article 30016).

Socket PL - 3/8" (Art. 30016)

Socket PL - 3/8" (Art. 30016)

Antenna adaptors etc.

Adaptor PL259/ 3/8" e.g. for magnet base or similiar, heavy duty model, chrome plated. Order No. 30007 7.70 € Buy now	Adapter PL259/DV, for DV radiators on a PL base, chrome plated. Order No. 30012 11.30 € Buy now	Adapter PL259/DV, as 30012, economy model, nickel plated. Order No. 30013 8.50 € Buy now
BNC adaptor with thread M8 x 0.75 for FT-290, TR-2300 or similiar. Order No. 30009 5.00 € Buy now	DV adaptor with PL or N jack (female) for antennas with PL or N base on a DV mount. Order No. 30010 PL jack 10.00 € Buy now 30010.01 N jack 10.80 € Buy now	Self adhesive cable guide for RG-58 Order No. 40016 0.50 € Buy now
Connector for DV base, 90 deg. angled, RG-58 Order No. 30001 2.50 € Buy now	Wing nut for DV mounts Order No. 30002 1.90 € Buy now
Adaptor DV to 3/8$quot; for all antennas with 3/8" base. Order No. 30004 5.10 € Buy now	Euro adaptor, mounting a DV base antenna on a 3/8" mount. Order No. 30005 6.80 € Buy now	Thread bolt 3/8" 25mm, stainless steel Order No. 30011 2.60 € Buy now
3/8" thread coupling, 20mm long Order No. 30015 7.50 € Buy now	Antenna base PL for Steel whip. Solid PL plug with clamp for antenna whip. Takes a steel whip with up to 2.5mm diameter, fastened with a headless screw. Order No. 30006 9.00 € Buy now	Protective caps for PL or N base, e.g. the base mounts. Protects the jack when antenna is not mounted. Brass, chrome plated. Order No. 30014 Metal chrome 3.70 € Buy now